Well Pump Repair in Columbia, TN
Diagnosis and repair when the water stops, sputters, or the pump will not shut off.
Most calls that start with no water do not end with a new pump. The controls fail far more often than the pump does: a pitted pressure switch, a failed capacitor in the control box, a tripped breaker, or a waterlogged pressure tank that makes the pump cycle itself to death. Each of those is a fraction of the cost of pulling the well.
A proper diagnosis works from the house back to the well. Power at the breaker, pressure at the tank, the switch cut-in and cut-out, then the amp draw on the pump itself. Amp draw is what tells you whether the motor is genuinely failing or just being asked to run against a stuck check valve. Anyone quoting a pump replacement without those readings is guessing with your money.
Typical cost: $150 - $500 for diagnosis and a component repair such as a pressure switch or capacitor
When well pump repair is the right call
- No water at any fixture, and the breaker has not tripped
- Pressure drops off in the shower after a minute or two
- The pump runs constantly, or clicks on and off every few seconds
- Air spitting from taps, or water that suddenly runs cloudy
Other services
Common questions
How do I know if it is the pump or something else?
You mostly do not from the house. Rapid cycling usually points at the pressure tank, not the pump. No water at all with the breaker holding usually points at the switch, the capacitor or the pump. The amp reading settles it.
Can a well pump be repaired rather than replaced?
The controls above ground are repairable and often should be. The submersible motor itself, several hundred feet down, is almost always replaced rather than rebuilt, because the labor to pull it dwarfs the part.
Does a plumber handle well pumps?
Some do, but a well and pump specialist has the reel, the pulling rig and the parts on the truck. A general plumber often has to subcontract the pulling anyway.
Get a quote on your well
Call and tell us what is going on with your well and where the property is. You will get a straight answer on what it actually needs, from a licensed contractor working Maury County.
Call (931) 429-3818